ploughmyfield.com

 The rocker cover is now in place, I’ve added gasket sealant to the top side of the gasket which is made of cork. hopefully this means I can remover the rocker cover with gasket attached to check the timing once the engine has run in and replace it again. Someone told me I should do this, check the tappets after running in. I’m not sure how long I have to leave it before I check then. If anyone knows please drop me an email. It really is starting to look like an engine. I’m now working on the air intake and the venturi section which is rather rattle. At some point I will have to give the block a coat of primer grey before I add to much to it and I can’t reach all the hard to reach corners.

Rocker Cover on

Manifolds inlet/exhaust to be added next