ploughmyfield.com

I had a sudden panic whilst replacing the thrust bearing on the clutch. The housing is not symetrical.  The arms that the springs connect to Which way round should it go?

Thrust Bearing Holder

So I went trawling through the photo’s I have taken when I took the tractor apart. A piece of advice take as many pictures as you can before and whilst you are doing anything. I found the photo I needed. I’m going to put a page together tip for restoring and before you start restoring. Taking photo’s will be on the list.

Archive clutch thrust picture

The housing gasket that connects the engine to the gearbox section tool about an hour to remove. I have to remember it is made of alloy and will require something to stop the galvanic corosion occuring.

I still have lots of cleaning up to do with this middle section. It is looking a lot claener though. I don’t want to remove any paint as it’s just the engine I’m working on for now. The main aim is to get it all working again. Then i can start stripping paint.

The next few pictures are a reminder to me what need doing.

Clean gasket surface

Housing from above

Housing from the side

Closer side view

And this is what I am trying to get back to. This was the tractor just before I started taking it apart.

Before

And finally, here is the best picture I could get of the ferguson model that comes with the magazine that has been launched. Its a small model so the photo isn’t great. It is a very detailed model. How accurate it it I also don’t know as I’ve researched TE-F20′s mostly.

Tractor Model